Coin Cleaning Blocks…

3D Printed Blocks…

When you clean coins your hands tend to get in the way, due to the size of the coins, with gloves being the ideal choice, but when the coin size dictates, that’s impractical, so you end up with fiberglass splinters, in your hands, fingers, and everywhere it shouldn’t be, also chemicals create a mess everywhere on your workstation or tray, I’m looking at these blocks as an answer to minimise the time spent clearing up afterward’s…

Although these 3D Printed Blocks are not a new idea, this set of three blocks was first printed out by Andrew Breed from Hartlepool in County Durham to hold the coins, whilst cleaning them, as his hands and fingers were cramping during the cleaning process, which gave him the idea of selling them to other people cleaning their coins…

Sold as a set of three, with sizes ranging from as small as 12mm up to 35mm, these are available in various colours and could be the perfect answer for when you clean your coins, each block has the coin size quite clearly stamped beside the respective size, & as the observant amongst you will note there are two sizes per hole thus allowing eighteen coins sizes to be cleaned…

I think my purple one is the best, as i can see the condition of the coin, as it’s being cleaned, and it contrasts better with the colours of the coins, also there must be another use for them, but as yet i haven’t found it yet…

Good Value at only £10 for the set of three + £ 2.50p PP via Yodel…

Payments are made via bank transfer or they can be collected from Hartlepool (TS26)

Create a website or blog at WordPress.com

Up ↑

%d bloggers like this: